Hydraulic Round Elbow Machine
Choose DCH-1250 using its material-specific thickness table and your finished segmented elbow requirements.
- Model
- DCH-1250
- Diameter
- 125–1250 mm
- Listed power
- 5 kW
Start with the material-specific range
DCH-1250 Material and Machine Tables
| Model | DCH-1250 |
|---|---|
| Diameter Range | 125–1250 mm |
| Maximum Speed | 120 m/min |
| Power | 5 kW |
| Hydraulic Oil Capacity | 55 L |
| Weight | 750 kg |
| Material | Working Thickness |
|---|---|
| Black Steel | 0.4–1.5 mm |
| Galvanized Steel | 0.4–1.2 mm |
| Stainless Steel | 0.4–0.8 mm |
| Aluminum | 0.4–1.2 mm |
Read the black, galvanized, stainless and aluminum rows separately. The largest thickness must not be applied to every material.
One diameter range does not define the finished fitting
125–1250 mm diameter
Provide elbow angle, radius, segment layout and joint profile together with diameter. Confirm workpiece support and access at short segments.
120 m/min listed maximum speed
Confirm what forming movement the figure describes. It is not a completed elbows-per-hour promise; include preparation, joining and handling.
Material change belongs in acceptance
- 01
Approve grade
Use the quoted thickness and finish.
- 02
Set configuration
Confirm diameter and joint tooling.
- 03
Make fitting
Demonstrate the complete segment assembly.
- 04
Inspect result
Check angle, seams and end connections.
Questions to settle before ordering
What stainless range is listed?
0.4–0.8 mm, subject to actual grade and configuration confirmation.
Is black steel capacity the same as galvanized?
The original table gives different material ranges; use the appropriate row.
Does maximum speed describe finished fitting output?
No. Confirm its definition and include the complete fabrication cycle.
What tooling should be quoted?
The required diameter, segment joints and fitting construction.
What proves suitability?
A representative completed fitting and agreed dimensional/joint inspection.
Tell Us Your Hydraulic Round Elbow Requirements
Send your elbow diameter, angle, material, sheet thickness and required electrical standard so we can confirm the DCH-1250 configuration.