Manual Plate Rolling Machine
Review hand-operated rolling from the actual curved panel or cylinder sample, material and operator work cycle. Model capacity remains to be confirmed.
- Drive
- Hand-operated
- Model / capacity
- To confirm
- Selection sample
- Curve or open shell
A curved sample tells more than a machine name
Start with the finished curve
For hand-operated rolling, specify whether the job is a partial curved panel or an open cylindrical shell. Provide the required inside or outside diameter convention and the width along the cylinder axis.
The same nominal thickness can represent very different manual work when grade, width and curvature change. Ask WinYing to review a representative sample and the operator work cycle before proposing a model.
Two practical sample briefs
A curved cover or panel
Send the section radius, developed blank, edge details and the dimensions used to check the curve. Review repeat setup and the accepted surface condition.
An open cylindrical shell
Provide diameter convention, axial width and the required seam gap or end condition. Confirm how the formed workpiece is removed from the quoted roll arrangement.
Make manual operation part of the comparison
- Actual materialUse the ordered grade, thickness and finish in the trial.
- HandlingReview positioning, support and manual drive operation at the planned width.
- Finished conditionAgree curvature, end straight sections, edge condition and later joining.
- RepeatabilityCheck setup and inspection for more than one workpiece.
Manual Rolling Configuration Record
| Selection item | Required confirmation |
|---|---|
| Selected model | Exact manual machine and current equipment photographs. |
| Rolling width / thickness | Combined capacity for the actual material. |
| Minimum finished diameter | Rating conditions and the diameter convention. |
| Roll arrangement / adjustment | Included rolls, adjustment and workpiece-release arrangement. |
| Footprint / shipment | Machine dimensions, mass and packed size. |
When to compare powered rolling
Compare a powered route if handling or the manual cycle does not fit repeated work. Use the same material and curve on both proposals. The hand-operated description does not establish a numeric manual thickness or diameter rating, and none is confirmed in the current source.
Questions to settle before ordering
What thickness can this manual roller handle?
No numeric model capacity is confirmed. Provide actual grade, thickness, width and curvature.
What diameter should I specify?
State the finished inside or outside diameter convention and the accepted curvature requirement.
Does the source confirm a roll count?
No. Obtain the selected roll arrangement and adjustment details.
Are the current photos model-specific?
The original source labels them website references. Request current photographs of the selected machine.
Can it make a complete welded cylinder?
Review rolling, end condition and later joining separately. A manual rolling description does not include welding.
Tell Us Your Plate Rolling Requirements
Tell us which plate rolling machine you need, plus material, thickness, working width, required diameter and production requirements.